Site MapHelpFeedbackMixed Quiz
Mixed Quiz
(See related pages)






1The supply voltage (VDD) for a JFET forces free electrons to flow from the source to the drain.
A)True
B)False



2The JFET is a current-controlled device because an input current controls an output voltage.
A)True
B)False



3The source and drain terminals are not interchangeable at high frequencies.
A)True
B)False



4In the schematic symbol for a p-channel JFET, the gate arrow points in.
A)True
B)False



5Gate bias is not the best way to bias a JFET in the active region because with gate bias the Q point is unstable.
A)True
B)False



6The unit mho is the ratio of voltage to current and the modern unit for mho is the joule.
A)True
B)False



7A JFET common-source amplifier produces an inverted output that is coupled from the drain.
A)True
B)False



8A JFET analog switch operates in the active region.
A)True
B)False



9A JFET chopper can be used to build an ac amplifier.
A)True
B)False



10Circuits that amplify frequencies down to 0 Hz are called amplifiers.



11A circuit that generates an ac signal is a(n) .



12Since the field-effect transistor depends on only one type of charge, it is referred to as .



13The is an amplifying device that is preferred for most linear applications.



14The JFET is a -controlled device.



15The minimum JFET voltage VP is called voltage.



16When the JFET operates in only the ohmic region or in the cutoff region, it is being used as an analog .



17A JFET circuit that converts a dc input voltage to a square-wave output is a(n) .



18What is a circuit that steers one or more of the input signals to the output line?
A)dc amplifier
B)regulator
C)oscillator
D)multiplexer



19A stage that isolates the preceding stage from the following stage is called a
A)chopper amplifier
B)driver amplifier
C)buffer amplifier
D)preamplifier



20In audio applications, JFETs are often used as
A)analog switches
B)tuned RF amplifiers
C)common-source amplifiers
D)source followers



21Which instrument cannot be used in the testing of a JFET?
A)curve tracer
B)oscilloscope
C)watt meter
D)DMM



22The current flowing from the JFET’s source to drain must pass through what between the depletion layers?
A)gate
B)ground
C)channel
D)base



23The almost-vertical part of the drain curve below pinchoff is called the
A)static region
B)channel
C)ohmic region
D)saturation



24Self-biasing a JFET is used only with
A)small-signal amplifiers
B)power amplifiers
C)wideband amplifiers
D)tuned RF amplifiers



25The JFET source follower has
A)low input resistance
B)high voltage gain
C)a voltage gain less than one
D)the output taken from the drain







Electronic Principles				Online Learning Center

Home > Chapter 13 > Mixed Quiz