Site MapHelpFeedbackMixed Quiz
Mixed Quiz
(See related pages)






1The half-wave rectifier has a diode in parallel with a load resistor.
A)True
B)False



2In electronic equipment power supplies, the transformer steps the line voltage up to higher levels that can more easily be used with semiconductor devices.
A)True
B)False



3The full-wave rectifier is equivalent to two half-wave rectifiers.
A)True
B)False



4The bridge rectifier is similar to a half-wave rectifier because it produces a half-wave output voltage.
A)True
B)False



5The choke-input filter is often used because of its low cost and light weight.
A)True
B)False



6The peak inverse voltage is the maximum voltage across the conducting diode of a rectifier.
A)True
B)False



7For low-voltage power supplies, the integrated circuit has been replaced by the LC filter.
A)True
B)False



8It is more often the case that equipment failure is caused by troubles in the power supply.
A)True
B)False



9A clamper is a circuit that removes either positive or negative parts of a waveform.
A)True
B)False



10A diode circuit used to protect a sensitive circuit is called a .



11Applying an external voltage to change the reference level of a circuit is called .



12A is a circuit that adds a dc voltage to the signal?



13If you a clamper and a peak detector, you get a peak-to-peak detector.



14Half-wave rectifier voltage produces current flow.



15A step-up transformer will produce a secondary voltage that is than the primary.



16Ac ripple measurements can be most accurately made by using a(n) .



17The is the most popular rectifier circuit.



18By using rectifier diodes and operating at 60 Hz, what type of power supply can be configured?
A)IC
B)voltage doubler
C)passive
D)clipper



19When neither end of a load resistor is grounded, the load resistor is said to be
A)open
B)shorted
C)a voltage divider
D)floating



20Phasing dots that appear at the upper ends of the transformer’s schematic symbol mean that the dotted ends have the
A)same instantaneous phase
B)opposite instantaneous phase
C)iron core insert
D)connection for 60 Hz input



21What is the small ac load voltage that can be measured (with an oscilloscope) at the output of a choke-input filter?
A)peak
B)ripple
C)surge
D)harmonic



22What is the term for a special kind of high frequency power supply used in computers and monitors?
A)crowbar protection
B)half-wave
C)bridge
D)switching regulator



23The voltage that must be less than the breakdown voltage of the diode as to prevent damage to the diode is the
A)peak inverse voltage
B)maximum diode voltage
C)reverse surge voltage
D)maximum peak voltage



24What is the type of fuse that can temporarily withstand overloads in current?
A)overload fuse
B)slow-blow fuse
C)temporary blow fuse
D)fast-acting fuse



25A circuit that removes all the positive parts of the input signal is a
A)positive clipper
B)positive clamper
C)negative clipper
D)positive voltage doubler







Electronic Principles				Online Learning Center

Home > Chapter 4 > Mixed Quiz