Site MapHelpFeedbackPractice Test
Practice Test
(See related pages)






1The two main characteristics of a resistor are its resistance in ohms and its power rating in watts.
A)True
B)False



2Carbon-composition resistors are made of finely divided carbon or graphite mixed with a powdered insulating material.
A)True
B)False



3A resistor that is color-coded red, green, orange has a value of 2500 ohms.
A)True
B)False



4The amount by which the actual resistance can differ from the color-coded value is the tolerance.
A)True
B)False



5Zero-ohm resistors are not commonly found on printed circuit boards.
A)True
B)False



6A rheostat has three terminals and a potentiometer has two terminals.
A)True
B)False



7A potentiometer can be wired as a rheostat.
A)True
B)False



8Carbon resistors are larger and have higher wattage ratings than wire-wound resistors.
A)True
B)False



9The most common trouble in resistors is a short.
A)True
B)False



10In electronic equipment, the resistor most commonly used is the type.



11A resistor whose resistance value changes with changes in operating temperature is a .



12The amount by which the actual resistance can differ from the color-coded value is the .



13A resistor with a single black band around the center of the resistor body has a resistance of .



14Variable resistors can be wire-wound or type.



15A device that is used to provide any one resistance within a wide range of values is a box.



16Rheostats and potentiometers are referred to as resistors.



17The power rating is a property of a resistor that depends on the resistor's .



18Two major characteristics of a resistor are
A)resistance in ohms and tolerance in percentage
B)resistance in ohms and power rating in watts
C)resistance in ohms and conductivity in mhos
D)resistance in ohms and power in joules



19What type of resistor is typically used as a precision resistor?
A)carbon
B)carbon-composition
C)film-type
D)wire-wound



20What is the resistor called that is designed to burn open easily when the power rating is exceeded?
A)thermistor
B)varistor
C)fusible
D)chip



21What type resistor is frequently used in electronic circuits in which it is desired to provide temperature control?
A)thermocouple
B)thermodynamic
C)thermistor
D)varistor



22The way resistance varies with shaft rotation in a variable resistor is called the
A)variable of the control
B)variance of the control
C)rheostat
D)taper of the control



23A variable resistance with two terminals that is connected in series with the load is a
A)potentiometer
B)rheostat
C)tunable transformer
D)varistor



24What is indicated when a volume or tone control makes a scratchy noise as the shaft is rotated?
A)shorted resistance element
B)open resistance element
C)worn or dirty resistance element
D)wrong resistance value



25What may cause a much lower resistance value to be displayed on an ohmmeter when checking resistance in a circuit?
A)low batteries in the ohmmeter
B)the circuit power is on
C)parallel resistance paths
D)open resistors







Grob's Basic ElectronicsOnline Learning Center

Home > Chapter 2 > Practice Test