Site MapHelpFeedbackMultiple Choice
Multiple Choice
(See related pages)

1
The feature control frame contains information on both the geometric control and the tolerance zone.
A)True
B)False
2
The feature control frame only contains information on size control, not form control.
A)True
B)False
3
Rule #1 states that variations in geometric form must be treated separately from variations in size.
A)True
B)False
4
The maximum material condition (MMC) of a hole is when it is its largest allowable size.
A)True
B)False
5
The only way a shaft can deviate from maximum material condition (MMC) is by getting larger.
A)True
B)False
6
The only way a pin can allowably depart from MMC is by getting smaller.
A)True
B)False
7
In actuality the flat plat of a height gage is a simulated datum, not a true datum.
A)True
B)False
8
The primary datum is farthest left hand flat surface on the part.
A)True
B)False
9
The virtual condition combines the least material condition (LMC) with the maximum allowed geometric distortion.
A)True
B)False
10
The angle of the secondary and tertiary datums relative to the primary datum must be specified on the drawing.
A)True
B)False





To learn more about the book this website supports, please visit its Information Center.
(c)2009 McGraw-Hill Higher Education
Any use is subject to the Terms of Use and Privacy Policy.
McGraw-Hill Higher Education is one of the many fine businesses of The McGraw-Hill Companies.


Tech. Graphics Communication 4Online Learning Center

Home > Chapter 18 > True/False Quiz Questions