Read each question carefully and then select the best answer.

1			On a drawing for use in American industry, all dimensions are in inches, unless otherwise stated.
			A)	True
			B)	False
2			Most drawings produced outside of the United States use the metric system of measure.
			A)	True
			B)	False
3			An extension line is used to associate a radius or diameter dimension with a circular feature.
			A)	True
			B)	False
4			There is a visible gap between the extension line and the feature's corner.
			A)	True
			B)	False
5			A datum is only a theoretically exact point.
			A)	True
			B)	False
6			The minimum spacing for the first dimension from the object is 6mm.
			A)	True
			B)	False
7			The spacing between the first and second dimension does not have to be the same as between the first dimension and the object
			A)	True
			B)	False
8			It is acceptable for extension lines to cross each other but it is not acceptable for extension lines to cross dimension lines.
			A)	True
			B)	False
9			Not-to-scale dimensions are acceptable as long as the dimension text is underlined.
			A)	True
			B)	False
10			Dimensions should always be placed in the adjacent view to the contour of a feature.
			A)	True
			B)	False
11			Datum dimensioning has all of the dimensions calculated from a common origin point.
			A)	True
			B)	False
12			A tolerance is the amount a dimension may vary between its average and maximum limit.
			A)	True
			B)	False
13			You would use a transition fit to guarantee that one part would be anchored to the other part.
			A)	True
			B)	False
14			The basic size is the size to which the limits of deviation are assigned.
			A)	True
			B)	False
15			The feature control frame contains information on both the geometric control and the tolerance zone.
			A)	True
			B)	False
16			The feature control frame only contains information on size control, not form control.
			A)	True
			B)	False
17			Rule #1 states that variations in geometric form must be treated separately from variations in size.
			A)	True
			B)	False
18			The maximum material condition (MMC) of a hole is when it is its largest allowable size.
			A)	True
			B)	False
19			The only way a shaft can deviate from maximum material condition (MMC) is by getting larger.
			A)	True
			B)	False
20			The only way a pin can allowably depart from MMC is by getting smaller.
			A)	True
			B)	False