Site MapHelpFeedbackMultiple Choice Questions
Multiple Choice Questions
(See related pages)

1
Which symbol is used to indicate a dimension refers to the diameter of a hole?
A)R
B)°
C)Ø
D)Ω
2
Which symbol is used with angular dimensions?
A)R
B)°
C)Ø
D)Ω
3
In _________________ dimensioning, a datum is established for each Cartesian coordinate direction.
A)baseline
B)symmetric
C)hole basis
D)none of the above
4
In current ANSI standards, a _____________ is indicated by a 'V' shaped symbol.
A)counterbore
B)datum surface
C)countersink
D)drill
5
A limited length or area (such as a polished end of shaft) is indicated with a _____________ line.
A)hidden
B)chain
C)section
D)dimension
6
In previous ANSI standards, a blind hole dimension would have to contain which designation?
A)DP
B)THRU
C)C'BORE
D)CSK
7
The _________________ of an external feature is the upper limit.
A)maximum material condition
B)runnout
C)minimum material condition
D)allowance
8
The _________________ of an internal feature is the upper limit.
A)maximum material condition
B)runnout
C)minimum material condition
D)allowance





To learn more about the book this website supports, please visit its Information Center.
(c)2003 McGraw-Hill Higher Education
Any use is subject to the Terms of Use and Privacy Policy.
McGraw-Hill Higher Education is one of the many fine businesses of The McGraw-Hill Companies.


Bertoline TGCOnline Learning Center

Home > Chapter 15 > Multiple Choice Questions