 |
1 | |
In a Go-Back-N ARQ, if the window size is 63, what is the range of sequence numbers? |
|
| | A) | 0 to 63 |
| | B) | 0 to 64 |
| | C) | 1 to 63 |
| | D) | 1 to 64 |
|
2 | |
In Go-Back-N ARQ, if frames 4, 5, and 6 are received successfully, the receiver may send an ACK _______ to the sender. |
|
| | A) | 5 |
| | B) | 6 |
| | C) | 7 |
| | D) | any of the above |
|
3 | |
ARQ stands for _______. |
|
| | A) | Automatic repeat quantization |
| | B) | Automatic repeat request |
| | C) | Automatic retransmission request |
| | D) | Acknowledge repeat request |
|
4 | |
For Stop-and-Wait ARQ, for 10 data packets sent, _______ acknowledgments are needed. |
|
| | A) | exactly 10 |
| | B) | less than 10 |
| | C) | more than 10 |
| | D) | none of the above |
|
5 | |
HDLC is an acronym for _______. |
|
| | A) | High-duplex line communication |
| | B) | High-level data link control |
| | C) | Half-duplex digital link combination |
| | D) | Host double-level circuit |
|
6 | |
Data link control deals with the design and procedures for ______ communication. |
|
| | A) | node-to-node |
| | B) | host-to-host |
| | C) | process-to-process |
| | D) | none of the above |
|
7 | |
_______ in the data link layer separates a message from one source to a destination, or from other messages going from other sources to other destinations. |
|
| | A) | Digitizing |
| | B) | Controlling |
| | C) | Framing |
| | D) | none of the above |
|
8 | |
In _______ framing, there is no need for defining the boundaries of frames. |
|
| | A) | fixed-size |
| | B) | variable-size |
| | C) | standard |
| | D) | none of the above |
|
9 | |
In ________ framing, we need a delimiter (flag) to define the boundary of two frames. |
|
| | A) | fixed-size |
| | B) | variable-size |
| | C) | standard |
| | D) | none of the above |
|
10 | |
_________framing uses two categories of protocols: character-oriented and bit-oriented. |
|
| | A) | Fixed-size |
| | B) | Variable-size |
| | C) | Standard |
| | D) | None of the above |
|
11 | |
In a ________ protocol, the data section of a frame is a sequence of characters. |
|
| | A) | bit-oriented |
| | B) | character-oriented |
| | C) | either (a) or (b) |
| | D) | none of the above |
|
12 | |
In a _________ protocol, the data section of a frame is a sequence of bits. |
|
| | A) | byte-oriented |
| | B) | bit-oriented |
| | C) | either (a) or (b) |
| | D) | none of the above |
|
13 | |
In _________ protocols, we use ________. |
|
| | A) | character-oriented; byte stuffing |
| | B) | character-oriented; bit stuffing |
| | C) | bit-oriented; character stuffing |
| | D) | none of the above |
|
14 | |
Byte stuffing means adding a special byte to the data section of the frame when there is a character with the same pattern as the ______. |
|
| | A) | header |
| | B) | trailer |
| | C) | flag |
| | D) | none of the above |
|
15 | |
In ________ protocols, we use ________. |
|
| | A) | byte-oriented; bit stuffing |
| | B) | character-oriented; bit stuffing |
| | C) | bit-oriented; bit stuffing |
| | D) | none of the above |
|
16 | |
Bit stuffing means adding an extra 0 to the data section of the frame when there is a sequence of bits with the same pattern as the ________. |
|
| | A) | header |
| | B) | trailer |
| | C) | flag |
| | D) | none of the above |
|
17 | |
_______ control refers to a set of procedures used to restrict the amount of data that the sender can send before waiting for acknowledgment. |
|
| | A) | Flow |
| | B) | Error |
| | C) | Transmission |
| | D) | none of the above |
|
18 | |
______ control refers to methods of error detection and correction. |
|
| | A) | Flow |
| | B) | Error |
| | C) | Transmission |
| | D) | none of the above |
|
19 | |
The Simplest Protocol and the Stop-and-Wait Protocol are for ______ channels. |
|
| | A) | noisy |
| | B) | noiseless |
| | C) | either (a) or (b) |
| | D) | neither (a) nor (b) |
|
20 | |
The Stop-And-Wait ARQ, Go-Back-N ARQ, and the Selective Repeat ARQ are for ______ channels. |
|
| | A) | noisy |
| | B) | noiseless |
| | C) | either (a) or (b) |
| | D) | neither (a) nor (b) |
|
21 | |
The ____ Protocol has neither flow nor error control. |
|
| | A) | Stop-and-Wait |
| | B) | Simplest |
| | C) | Go-Back-N ARQ |
| | D) | Selective-Repeat ARQ |
|
22 | |
The _______Protocol has flow control, but not error control. |
|
| | A) | Stop-and-Wait |
| | B) | Simplest |
| | C) | Go-Back-N ARQ |
| | D) | Selective-Repeat ARQ |
|
23 | |
The _______Protocol has both flow control and error control. |
|
| | A) | Stop-and-Wait |
| | B) | Go-Back-N ARQ |
| | C) | Selective-Repeat ARQ |
| | D) | both (b) and (c) |
|
24 | |
In the _____ Protocol, the sender sends its frames one after another with no regard to the receiver. |
|
| | A) | Stop-and-Wait |
| | B) | Simplest |
| | C) | Go-Back-N ARQ |
| | D) | Selective-Repeat ARQ |
|
25 | |
In the _____ Protocol, the sender sends one frame, stops until it receives confirmation from the receiver, and then sends the next frame. |
|
| | A) | Stop-and-Wait |
| | B) | Simplest |
| | C) | Go-Back-N ARQ |
| | D) | Selective-Repeat ARQ |
|
26 | |
The _________Protocol, adds a simple error control mechanism to the _______Protocol. |
|
| | A) | Stop-and-Wait ARQ; Stop-and-Wait |
| | B) | Go-Back-N ARQ; Stop-and-Wait |
| | C) | Selective Repeat ARQ; Go-Back-N ARQ |
| | D) | none of the above |
|
27 | |
In the _________Protocol, if no acknowledgment for a frame has arrived, we resend all outstanding frames. |
|
| | A) | Stop-and-Wait ARQ |
| | B) | Go-Back-N ARQ |
| | C) | Selective-Repeat ARQ |
| | D) | none of the above |
|
28 | |
In the _________ protocol we avoid unnecessary transmission by sending only frames that are corrupted. |
|
| | A) | Stop-and-Wait ARQ |
| | B) | Go-Back-N ARQ |
| | C) | Selective-Repeat ARQ |
| | D) | none of the above |
|
29 | |
Both Go-Back-N and Selective-Repeat Protocols use a _________. |
|
| | A) | sliding frame |
| | B) | sliding window |
| | C) | sliding packet |
| | D) | none of the above |
|
30 | |
In Go-Back-N ARQ, if 5 is the number of bits for the sequence number, then the maximum size of the send window must be _____ |
|
| | A) | 15 |
| | B) | 16 |
| | C) | 31 |
| | D) | 1 |
|
31 | |
In Go-Back-N ARQ, if 5 is the number of bits for the sequence number, then the maximum size of the receive window must be _____ |
|
| | A) | 15 |
| | B) | 16 |
| | C) | 31 |
| | D) | 1 |
|
32 | |
In Selective Repeat ARQ, if 5 is the number of bits for the sequence number, then the maximum size of the send window must be _____ |
|
| | A) | 15 |
| | B) | 16 |
| | C) | 31 |
| | D) | 1 |
|
33 | |
In Selective Repeat ARQ, if 5 is the number of bits for the sequence number, then the maximum size of the receive window must be _____ |
|
| | A) | 15 |
| | B) | 16 |
| | C) | 31 |
| | D) | 1 |
|
34 | |
High-level Data Link Control (HDLC) is a _______ protocol for communication over point-to-point and multipoint links. |
|
| | A) | bit-oriented |
| | B) | byte-oriented |
| | C) | character-oriented |
| | D) | none of the above |
|
35 | |
The most common protocol for point-to-point access is the Point-to-Point Protocol (PPP), which is a _________protocol. |
|
| | A) | bit-oriented |
| | B) | byte-oriented |
| | C) | character-oriented |
| | D) | none of the above |
|
36 | |
_______ control refers to a set of procedures used to restrict the amount of data that the sender can send before waiting for acknowledgment. |
|
| | A) | Flow |
| | B) | Error |
| | C) | Transmission |
| | D) | none of the above |
|
37 | |
_________control in the data link layer is based on automatic repeat request, which is the retransmission of data. |
|
| | A) | Flow |
| | B) | Error |
| | C) | Transmission |
| | D) | none of the above |
|
38 | |
In Stop-and-Wait ARQ, we use sequence numbers to number the frames. The sequence numbers are based on __________arithmetic. |
|
| | A) | modulo-2 |
| | B) | modulo-4 |
| | C) | modulo-m |
| | D) | none of the above |
|
39 | |
In Stop-and-Wait ARQ, the acknowledgment number always announces in ______ arithmetic the sequence number of the next frame expected. |
|
| | A) | modulo-2 |
| | B) | modulo-4 |
| | C) | modulo-m |
| | D) | none of the above |
|
40 | |
In the Go-Back-N Protocol, if the size of the sequence number field is 8, the sequence numbers are in ________ arithmetic, |
|
| | A) | modulo-2 |
| | B) | modulo- 8 |
| | C) | modulo-256 |
| | D) | none of the above |
|
41 | |
Stop-and-Wait ARQ is a special case of Go-Back-N ARQ in which the size of the send window is 1. |
|
| | A) | 2 |
| | B) | 1 |
| | C) | 8 |
| | D) | none of the above |
|
42 | |
In _________, the station configuration is unbalanced. We have one primary station and multiple secondary stations. |
|
| | A) | ABM |
| | B) | NRM |
| | C) | ARM |
| | D) | NBM |
|
43 | |
In _________, the configuration is balanced. The link is point-to-point, and each station can function as a primary and a secondary. |
|
| | A) | ABM |
| | B) | NRM |
| | C) | ARM |
| | D) | NBM |
|
44 | |
In PPP, the ________ is responsible for establishing, maintaining, configuring, and terminating links. |
|
| | A) | NCP |
| | B) | LCP |
| | C) | CHAP |
| | D) | PAP |
|
45 | |
In PPP, ________ is a simple authentication procedure with a two-step process: |
|
| | A) | NCP |
| | B) | LCP |
| | C) | CHAP |
| | D) | PAP |
|
46 | |
In PPP, _______ is a three-way hand-shaking authentication protocol in which the password is kept secret; it is never sent online. |
|
| | A) | NCP |
| | B) | LCP |
| | C) | CHAP |
| | D) | PAP |