1. Mass wasting is movement of bedrock, rock debris or soil downslope as
a mass in response to gravity.
2. Mass wasting is classified on the basis of rate of movement, type of material,
and nature movement. Rates vary from slow (< 1 cm/year) to rapid. Types
of material include bedrock, unconsolidated debris, and soil. Movements include
flow (movement as viscous fluid), slide (movement as coherent mass along defined
surface), and fall (free-fall).
3. Slides may be either translational (plane parallel to slope) or rotational
(also called slump) (movement along a curved surface).
4. Factors promoting mass wasting include: steep slopes, high local relief,
thick debris above bedrock, planes of weakness parallel to hillside, freeze
and thaw, saturation of debris with water, long periods of drought with episodes
of heavy precipitation, and sparse vegetation (Table 13.2).
5. Gravity is the driving force for mass wasting. Shear force is parallel
to slope. Shear strength is resistance to movement or deformation. If shear
force is greater than shear strength, mass wasting occurs.
6. Water is a critical factor in mass wasting. Small amounts of water actually
inhibit mass wasting because surface tension increases shear strength. As
the water content increases, the rate of movement increases, for example a
change from creep to mudflow.
7. Creep is very slow, continuous downslope movement of soil or unconsolidated
debris promoted by water in the soil and cycles of freeze and thaw where shear
forces are slightly greater than shear strength.
8. Debris flows are mass wasting taking place as a moving mass, including
earthflows, mudflows and debris avalanches. Earthflow is slow or rapid downslope
movement of water saturated debris as a viscous fluid. Rotational sliding
(movement along a curved surface) (previously called slumping) is commonly
associated with earthflow. Solifluction is a variety of earthflow that occurs
above permafrost in colder climates. Mudflow is a flowing mixture of debris
and water usually moving in a channel. Debris avalanche is a very rapidly
moving mass of debris, air and water.
9. Rockfalls are blocks of bedrock that fall freely or bounce down a cliff.
A rockslide is a mass of bedrock moving along an inclined surface; a rock
avalanche is a larger version of the same process. Debris slides and debris
falls are the same process involving movement of a coherent mass of debris
rather than bedrock.
10. Landslides can be prevented by recognizing potential problems and proper
engineering. Avoiding oversteepening of slopes and undercutting slopes as
well as providing adequate drainage for excess water are useful measures.
