Site MapHelpFeedbackTrue or False
True or False
(See related pages)

1
In a turning operation the stock rotates as opposed to a milling operation where the stock does not rotate.
A)True
B)False
2
When turning stock with a length to diameter ratio of less than 5 to 1, you need center supports when turning.
A)True
B)False
3
To position the tool to cut a smaller diameter, you move the tool in the X axis.
A)True
B)False
4
The Z axis is fed by a precision lead screw.
A)True
B)False
5
It is good practice to clean the spindle taper and chuck before mating them.
A)True
B)False





To learn more about the book this website supports, please visit its Information Center.
Copyright (c)2014 McGraw-Hill Education .
Any use is subject to the Terms of Use and Privacy Notice | Report Piracy


Fitzpatrick, 3eOnline Learning Center

Home > Chapter 11 > True or False