Site MapHelpFeedbackMultiple Choice Quiz
Multiple Choice Quiz
(See related pages)

1
Which is not an advantage of carbide insert cutters:
A)they are sharper than HSS
B)they remove metal faster
C)many tool geometry choices
D)they have a longer tool life
2
Which following are disadvantages to carbide insert cutters?
A)they are less sharp and cause more heat
B)they have a high initial cost
C)they are vulnerable to breakage
D)all of these are correct
3
Which is not a good tip for setting up work in a vise?
A)Make the solid jaw the datum
B)Tap clamped piece with brass faced hammer
C)Hold work down low
D)Clamping a part with sides that are not square to its base
4
Cutting speeds that are too high may cause:
A)heat
B)chatter
C)cutter dulling
D)all of these are correct
5
In a vertical mill the _______ axis travels up and down.
A)rotary
B)drive
C)Z
D)X





To learn more about the book this website supports, please visit its Information Center.
Copyright (c)2014 McGraw-Hill Education .
Any use is subject to the Terms of Use and Privacy Notice | Report Piracy


Fitzpatrick, 3eOnline Learning Center

Home > Chapter 12 > Multiple Choice Quiz