Site MapHelpFeedbackMultiple Choice Quiz
Multiple Choice Quiz
(See related pages)

1
The code, G01, commands the machine to move:
A)at rapid travel
B)in a straight line
C)in a circle clockwise
D)at a feed rate of 1.0 inches per minute
2
M codes are considered ____________ functions.
A)manual
B)miscellaneous
C)coordinate system
D)machine operator
3
You do not need to know the _____________________ to create an arc command.
A)arc direction
B)start coordinate
C)end coordinate
D)tool diameter
4
The G41 command (tool offset) will remain modal until the program reaches ____ , the cancel command.
A)M09
B)G00
C)G40
D)M03
5
In the program line: T01 M06; the T code refers to the ____________________ number.
A)line
B)program
C)tool
D)tool diameter offset





To learn more about the book this website supports, please visit its Information Center.
Copyright (c)2014 McGraw-Hill Education .
Any use is subject to the Terms of Use and Privacy Notice | Report Piracy


Fitzpatrick, 3eOnline Learning Center

Home > Chapter 22 > Multiple Choice Quiz