Site MapHelpFeedbackMultiple Choice Quiz
Multiple Choice Quiz
(See related pages)

1
A relief behind the edge that prevents the tool from rubbing on the finished surface is called the ______________.
A)clearance angle
B)corner radius
C)deformation
D)lead angle
2
The permanent bending of any metal, in this case, of the chip as it is raked is called:
A)deformation
B)rake
C)cornering
D)chatter
3
Which of the following can be an undesired result of increasing the lead angle of a tool?
A)smoother entry and exit
B)longer tool life
C)better finishes on the work
D)increased chatter
4
Which of the following should be tried to create a better surface finish?
A)change in speed
B)use of coolants
C)change rake angle
D)all of these are correct
5
Which does not likely cause the tool to burn quickly?
A)feed rate is too high
B)cutting speed is too high
C)carbide grade is too hard
D)lack of cutting fluid





To learn more about the book this website supports, please visit its Information Center.
Copyright (c)2014 McGraw-Hill Education .
Any use is subject to the Terms of Use and Privacy Notice | Report Piracy


Fitzpatrick, 3eOnline Learning Center

Home > Chapter 9 > Multiple Choice Quiz