Site MapHelpFeedbackMultiple Choice Questions
Multiple Choice Questions
(See related pages)

1
A section view usually shows __________ details.
A)exterior
B)interior
C)profile
D)foreshortened
2
What are the lines in a section view used to show where the material is cut called?
A)cutting plane lines
B)section lines
C)object lines
D)hidden lines
3
When are ribs sectioned?
A)When they are perpendicular to the cutting plane
B)When they are parallel to the cutting plane
C)Ribs are always sectioned
D)Ribs are never sectioned
4
When a quarter of the object is removed, the section is a:
A)full section
B)half section
C)quarter section
D)eighth section
5
The direction of line of sight of a section is indicated by the:
A)viewing direction of the section
B)offset section in the section
C)arrows at the end of the cutting plane line
D)dashed lines on the section
6
A(n) __________ is a section view drawing in which the cutting plane is perpendicularly bent to pass through all important interior details.
A)full section
B)revolved section
C)offset section
D)broken-out section
7
A __________ section makes use of a short break line.
A)whole
B)offset
C)revolved
D)broken-out
8
Cutting plane lines compared to object lines are:
A)lighter & thinner
B)darker & thinner
C)same darkness & thicker
D)same darkness & thinner
9
Section lines compared to object lines are:
A)lighter & thinner
B)darker & thinner
C)same darkness & thicker
D)same darkness & thinner
10
In an assembly section which of the following parts are not sectioned?
A)threaded fasteners
B)plastics
C)the smallest piece
D)the outer piece
11
In an assembly section a thin washer, gasket, or sheet metal is described by:
A)the cast iron crosshatching symbol.
B)not crosshatching it.
C)not showing it.
D)darkening it entirely black.
12
A section view that shows the section superimposed on a standard view is a(n):
A)auxiliary section
B)removed section
C)revolved section
D)offset section
13
A section is identified by use of:
A)a conventional break
B)a reference plane
C)a reference line
D)a cutting plane
14
When a cutting plane is located in a view:
A)all other views are shown with a segment removed
B)only the view where the cutting plane arrows is pointing is sectioned
C)an adjacent view is sectioned
D)none of the adjacent views are sectioned
15
A ____________________ is used mainly to expose small portions of the interior of an object.
A)revolved section
B)removed section
C)broken-out section
D)none of the above
16
A __________section is used when the section view will be placed in another drawing sheet.
A)revolved
B)removed
C)offset
D)phantom
17
The purpose of the arrowheads on a cutting plane line is to:
A)show the direction in which the imaginary cut surface is viewed
B)indicate the location of the cutting plane
C)identify the reference letters such as section A-A or B-B, etc.
D)all of the above





To learn more about the book this website supports, please visit its Information Center.
(c)2003 McGraw-Hill Higher Education
Any use is subject to the Terms of Use and Privacy Policy.
McGraw-Hill Higher Education is one of the many fine businesses of The McGraw-Hill Companies.


Bertoline TGCOnline Learning Center

Home > Chapter 14 > Multiple Choice Questions