 |
| 1 | |
Do size dimensions alone control the shapes of features? |
| | |
|
|
|
| 2 | |
Write a definition of what Rule #1 means for washer with the following specifications: .500 ID, 1.000 OD, .062 thickness, and a tolerance of plus or minus 0.005. |
| | |
|
|
|
| 3 | |
Describe the difference between the MMC condition of a shaft and the MMC condition of a hole. |
| | |
|
|
|
| 4 | |
How does a shaft depart from MMC? How does a hole depart from MMC? |
| | |
|
|
|
| 5 | |
Under the condition of Rule #1, if a shaft is at its absolute maximum size, can it be less than perfectly round? |
| | |
|
|
|
| 6 | |
What is the difference between a datum and a datum feature? |
| | |
|
|
|
| 7 | |
Why is a cylinder a good secondary datum? Why is it a poor primary datum? |
| | |
|
|
|
| 8 | |
Define virtual condition. |
| | |
|
|
|
| 9 | |
Why is a hole a feature of size? Why isn't a flat surface of a part a feature of size? |
| | |
|
|
|
| 10 | |
Describe the difference between position, concentricity, and runout. |
| | |
|
|