Site MapHelpFeedbackMultiple Choice Quiz
Multiple Choice Quiz
(See related pages)

1
Which symbol is used to indicate a dimension refers to the diameter of a hole?
A)R
B)°
C)Ø
D)Ω
2
Which symbol is used with angular dimensions?
A)R
B)°
C)Ø
D)Ω
3
In _________________ dimensioning, a datum is established for each Cartesian coordinate direction.
A)baseline
B)symmetric
C)hole basis
D)none of the above
4
In current ANSI standards, a _____________ is indicated by a 'V' shaped symbol.
A)counterbore
B)datum surface
C)countersink
D)drill
5
A limited length or area (such as a polished end of shaft) is indicated with a _____________ line.
A)hidden
B)chain
C)section
D)dimension
6
In previous ANSI standards, a blind hole dimension would have to contain which designation?
A)DP
B)THRU
C)C’BORE
D)CSK
7
The _________________ of an external feature is the upper limit.
A)maximum material condition
B)runnout
C)minimum material condition
D)allowance
8
The _________________ of an internal feature is the upper limit.
A)maximum material condition
B)runnout
C)minimum material condition
D)allowance
9
All of the following are true about surface texture symbols are true, except:
A)finish marks are only shown in views where the surface is visible
B)they are critical for interpreting the friction performance of a part
C)they are determined by the standard ANSI Y14.36-1978
D)the symbol is similar to a check mark





To learn more about the book this website supports, please visit its Information Center.
(c)2009 McGraw-Hill Higher Education
Any use is subject to the Terms of Use and Privacy Policy.
McGraw-Hill Higher Education is one of the many fine businesses of The McGraw-Hill Companies.


Tech. Graphics Communication 4Online Learning Center

Home > Chapter 17 > Multiple Choice Quiz