Applying AutoCAD © 2007

Chapter 15: Solid and Curved Objects


1.	The thick lines that are used on electrical/electronics drawings to represent the metal conductor etched into a PC board are called

		A)	wires.
		B)	splines.
		C)	traces.
		D)	squiggles.

2.	To produce solid-filled objects, you should use the

		A)	SOLID command.
		B)	SOLIDFILL command.
		C)	COLOR command.
		D)	2DSOLID command.

3.	The appearance of solids, wide polylines, multilines, and hatches is controlled by the

		A)	2DSOLID command.
		B)	FILL command.
		C)	PEDIT command.
		D)	HATCH command.

4.	To create a polyline, use the

		A)	POLYLINE command.
		B)	PLINE command.
		C)	LINE command.
		D)	PEDIT command.

5.	To convert a polyline into a spline curve, use the

		A)	SPLINE command.
		B)	PLINE command.
		C)	SPLINEDIT command.
		D)	PEDIT command.

6.	The most accurate way to edit a spline is to use the

		A)	SPLINE command.
		B)	PLINE command.
		C)	SPLINEDIT command.
		D)	PEDIT command.

7.	Which command allows you to change the characteristic of an existing polyline?

		A)	SPLINE command
		B)	PLINE command
		C)	SPLINEDIT command
		D)	PEDIT command

8.	Which of these commands causes a wide polyline to lose its width information?

		A)	SPLINE command
		B)	FILL command
		C)	SPLINEDIT command
		D)	EXPLODE command